Off-Road.gr

Θέματα Forums Αρχεία

  · Κεντρική σελίδα

Επιλογές
· Θέματα
· Κορυφαία άρθρα
· Αγγελίες
· Αναζήτηση

-------------------------
· Συζητήσεις - Forums
· Downloads
· Σύνδεσμοι
· Λέσχες
 


Web Links
  · NoraStudio.gr
· Motobet
· Nora Agapi - Photographer
· TheWorldOffRoad.com
· Νάουσα Ημαθίας
· Qashqai Club
· Η ιστοσελίδα των Μεθάνων
· Σύλλογος Τετρακίνησης Μαγνησίας
· JimnyClub.gr
· MotoRidersClub
 

 
Steering stem bearing service

Find location for zerk fitting that clears all cables and wires. Loosen steering stem slightly, center punch location, drill hole,tap threads in hole, install zerk fitting, fill steering crown cavity with grease until it showes at top and bottom.

I suggest a hand grease gun. Tighten steering stem to factory specs. On bikes that have a steering lock, the stem has to be removed. The hole for the lock has to be covered. The lock will no longer work. I cut a piece of alum can about 1/4" larger than hole. You can use J B weld or other similar product to hold patch in place. When patch is secure, install stem and complete the above procedure. Click on pictures for better view. Questions? corky255@juno.com

Tools needed, electric drill, center punch, # 3 drill, 1/4-28 tap, zerk fitting, 8mm wrench
Tools needed, electric drill, center punch, # 3 drill, 1/4-28 tap, zerk fitting, 8mm wrench
DRZ-S Steering stem with hole for steering lock
DRZ-S Steering stem with hole for steering lock
DRZ-E with zerk installed
DRZ-E with zerk installed

click on thumbnails for full image

Σημείωση by Corky....

Thanks a lot


More articles

 

 


 


 
Επιλέξτε γλώσσα

ΑγγλικήΕλληνική
 


 
Google
 



[ Page created in 0.040032 seconds. ]