vayero4_4 έγραψε:Τελος, επειδη παιζω τις τελευταιες μερες με ενα QTEK 2020i και ενα HTC TyTN, αμφοτερα συνδεδεμενα με BT GPS, θα ελεγα σε οποιον θελει να παρει pda + τηλεφωνο να προτιμησει καποιο που να εχει ενσωματωμενο gps. Το τι τραβηξα με τα 2 τηλεφωνα και τις com-ports δε λεγεται. Αλλες φορες τις βλεπουν τα προγραμματα, αλλες φορες δεν τις βλεπουν, ενας χαμος. Κι ακομα δεν τα εχω σταθεροποιησει. Γι αυτο σας λεω, ενσωματωμενο gps για να εχετε το κεφαλι σας (σχεδον) ησυχο.
πες μου αν ξερεις πως θα κανω το ozi να βρει την comport σε TyTN
που το παλευω και εγω.
με το destinator6 ειναι οκ αλλα αυτο το ozi δεν θελει να βρει την com
του bluetooth.
http://www.oziexplorer3.com/support/ozi ... ls1100.zip
αυτο βοηθαει?
Bluetooth Tools
Please note the Bluetooth tools may no longer be required for OziExplorerCE version 1.12.0 or later. OziExplorerCE has been rewritten to bypass the issues with the Bluetooth on these PDA's.
If you are using a O2 XDA II or MDA II or Qtek 2020 or any other PDA's based on the same hardware with a bluetooth gps then you will not be able to connect to the gps with OziExplorerCE, you will get ERR in the top right corner above the map. This is not a problem with OziExplorerCE it is a well known problem with these devices, their bluetooth implementation does not work properly and requires a patch.
There are some programs which do work with these devices without the patch but these are most likely using simple polling of the serial port. I can also read the serial port using polling but this is not a suitable method to use as it slows the software down considerably, an event driven reading method must be used and this is where the patch is required.
Setup for the Bluetooth Tools
* If you have any paired devices delete them.
* Download and install the Bluetooth Tools to the PDA.
* Reset the PDA.
* Run the bluetooth manager.
* Using the bluetooth manager search for the gps
* When found highlight it in the list and click on Next
* Enter the Device PIN: (should be in the gps manual, if not try 0000);
* Click Next
* Click Finish
* When asked if you want to create a Bluetooth serial port answer Yes.
* The serial port number that will be used is shown (remember the number, you will need it to configure OziExplorerCE) Tick the Serial port box
* Press the (ok) button on the top right of the screen to close the bluetooth manager (need to press 2 times)
* Reset the PDA (this is important, if you do not do this the new serial port will not be created)
Run OziExplorerCE and in NMEA (GPS) configuration set the Serial Port Number created by the Bluetooth Tools as the Communication Port.